Kit contains a LR Wideband Bodypack Receiver, Sennheiser MD 46 Handheld Microphone, HMa Plug-on Transmitter, and 18" TA3F to XLR3M cable.
LR Wideband Bodypack Receiver
The ultra-compact LR receiver takes the Lectrosonics Digital Hybrid Wireless® compact receiver concept to an entirely new level. Designed to be ultra-portable for use with DSLR, 4/3, small 4K, and other compact HD cameras, the LR's diminutive size belies the technology inside. The wide tuning bandwidth with tracking front-end filters provides plenty of flexibility while avoiding the vulnerabilities of wider pass bands. Tuning steps are user selectable at 25 or 100 kHz, yielding up to 3,072 operating frequencies.
Compatibility modes enable the LR to operate with older analog transmitters. Dual antenna diversity improves range and resistance to dropouts. The RF spectrum analyzer and Lectrosonics’ SmartTune capability make quick work of finding clean frequencies on site. A large, backlit LCD provides instant, clear information for setup and status monitoring while operational. Detachable antennas allow for remote antenna mounting.
The LT is housed in the latest machined aluminum shell with super-hard EbNi ‘Ebony’ conductive finish. The unit is powered with two AA batteries.
The HMa Digital Hybrid Wireless UHF Plug-on Transmitter's unique design will ideally match any microphone or line level source via a standard XLR connector. Phantom power is selectable at 5, 15 and 48 volts, or can be turned off for use with dynamic microphones and line level signal sources.
The design includes a wide tuning range of up to 76 MHz, with tuning steps in increments of 100 kHz or 25 kHz for up to 3072 frequencies. The tuning range covers three standard 25.6 MHz Lectrosonics frequency blocks. Each of the standard blocks includes 256 different pilot tone frequencies for compatibility with all Digital Hybrid Wireless receivers.
Sennheiser MD 46
The MD 46 cardioid interview mic focuses on the subject, increasing clarity while reducing background noise. Designed to deliver low handling and wind noise, and to eliminate vocal popping, this microphone gives the ENG team an ideal interview tool.
Starting in 2017, the 617-652 MHz and 663-698 MHz frequencies are being transitioned by the Federal Communications Commission (FCC). Users of wireless microphone devices that operate in any portion of those frequencies must cease operating on these frequencies no later than July 13, 2020. In addition, users of this device may be required to cease operations earlier than that date if their operations could cause harmful interference to a 600 MHz service licensee’s wireless operations on these frequencies. For more information, visit the FCC’s wireless microphone website at www.fcc.gov/wireless-microphones-guide or call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC).
Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device.
[email protected] (212) 629-9430[email protected] (404) 855-2255