Compatible with AAA,AA,C,D and 9V rechargeable and alkaline batteries.
Universal battery tester for AAA, AA, C, D, 9V, CR123A, button cells batteries, and more.
Holds eight standard-size nine-volt batteries.
Holds ten standard-size AA batteries.
Holds eight standard-size CR123A batteries. Available in brown and green.
Ultra-compact headphone amplifier system for studio and stage applications with per channel level control.
Connect guitars, basses and keyboards and other line-level devices to audio mixers and recorders while preserving and optimizing the source signal.
Adapts a Lemo 3-pin lavalier connector (e.g. older Sennheiser wireless, Zaxcom, and Wisycom tx) to 3.5mm (1/8") for use with the Sennheiser G3 and AVX tx.
Sturdy, reusable cable ties. 10 per package
Deluxe cable ties. Available in blue, green, red, and black.
Allows two wireless channels of input into a 302, 442, 552, or 664 mixer via the Link I/O or Mix In connector.
Simple plug-in DC voltage checker tests for the presence of phantom power, intercom, and more.
Flexible antenna or microphone mount on a clamp
Safe for electronics. Red "straw" included.
Sticker-backed foam for padding shoes and other noisy contact points. Sold in bulk in a 25 foot roll.
Sticker-backed foam for padding shoes and other noisy contact points. Sold by the square foot.
Sold by the square foot.
Two-sided blanket to provide comfortable protection in both heat and cold.
Effective adhesive tape that won't damage surfaces.
3/8" female thread to 5/8" 27 gauge male thread.
Offsets a camera shoe 2.6" vertically, and 2.24" to the left or right
Repositions camera shoe 2" above camera
For mounting multiple accessories on a camera shoe.
Provides a flat surface for mounting accessories to a camera shoe.
Adapts a Lemo 3-pin lavalier connector (e.g. older Sennheiser wireless, Zaxcom, and Wisycom tx) to 3.5mm for use with the Sennheiser G3 and AVX tx.
Adapts a Lemo 3-pin lavalier connector (e.g. older Sennheiser wireless, Zaxcom, and Wisycom tx) to TA5F for use with Lectrosonics tx.
Battery eliminator replaces the batteries and door on the LR receiver to allow for DC power.
Battery eliminator replaces the batteries and door on the LT transmitter, allowing for DC power.
Replaces an NP-1 battery with AC power.
43" long belt with pouch for use with Lectro SMQs, Zaxcom TRX900s, and other dual battery transmitters.
Hypoallergenic waterproof tape. Ideal for securing lavaliers to skin. 5 yards.
Portable power bank with dual USB output for charging digital devices.
Moisture eliminator for use in cases where moisture control is an absolute necessity.
Wireless 2.4 GHz in-ear audio receiver.
Expands the range of the Roger earpiece approximately 50m per repeater.
Automatically reprograms Roger Earpieces within 2m to its frequency.
Allows 12T microphones to operate with 48V phantom power.
Provides transformer isolation between equipment.
Easy to install wheel kit for PSC EuroCart.
10 sheets, totalling 240 pieces.
Precut and drilled lavalier mic quieting sleeves. 15 pieces.
Attenuates line level signals by 50dB to provide mic level output.
RF Protection for the RF Explorer WSUB1G, ISM Combo, 2.4G, and 433M-915M. Not required for WSUB3G 3G Combo, which has a built-in power limiter.
Allows attachment of a 3/8" thread accessory to a shoe mount.
Power adapter for external powering Sennheiser G3 receivers. Available wired for Hirose4, BDS, or unterminated.
Removes ground loop hum, mode noise & differentially induced hum in one device.
One foot cable for recording from an XLR mic on a mobile device. 3.5mm monitoring tap included
No connectors. Requires soldering.
Can be set to 15, 20, or 25 dB. Passes phantom power
Used to connect balanced and unbalanced devices having different signal levels or impedances.
Helps to eliminate electrical and mechanical noise in an audio system such as 60Hz electrical hum from AC power lines, low-frequency rumble caused by wind noise or air conditioning system, and stage/floor noise transmitted to a microphone through the microphone stand
Converts balanced line level signals to microphone level (50dB attenuation)
Reverses the phase (polarity) of a balanced audio signal. In line switch permits selection of normal or reversed polarity for comparison purposes.
RF filter, XLR in/out. Passes phantom power
700 Hz microphone-level signal
Transforms your XLR microphone to a USB microphone for digital recording.
For padding high heels. Available in clear and black.
Protective, clear Lexan LCD covers for the 702, 702T, 722, 744T, and 788T.
For 552, 664, MixPre, MixPre-D, or MP-2 tape output to 442/302 mix in.
Weighted attachment for lav connectors for easy wire dropping through clothes with interchangeable 3-Pin Lemo, Sennheiser, and Ta5F (Lectrosonics) adapters.
Weighted attachment for lav connectors for easy wire dropping through clothes.
Allows the Lav-Bullet, Lav-Rod, and Mic Drop blank models to be used with lavaliers featuring locking TA5/Mini XLR connectors, including many Lectrosonics' wirings.
Allows the Lav-Bullet, Lav-Rod, and Mic Drop blank models to be used with lavaliers with locking and push-pull 3-pin Lemo connectors.
Allows the Lav-Bullet, Lav-Rod, and Mic Drop blank models to be used with lavaliers wire for the Sennheiser G2/3 and other lavaliers with 1/8" locking stereo mini connectors.
Perfect for tricky wiring situations with tight clothing. Available in standard and foldable quick disconnect versions.
Flip mount for using a small tablet with an ENG audio bag.
Combines production and walkie talkie audio to a single headphone feed.
Combines production and walkie talkie audio into a single headphone feed with switchable walkie audio channels.
Non-lubricated latex condom used to protect electronic equipment from moisture.
2 inch wide, 15 foot long roll of velcro that includes both the hook and loop sides
Rounded rubber foam bumper suitable for any VdB boom pole.
Neoprene reversible belt with integrated pouch for single and double battery transmitters
Converts a line or instrument level unbalanced signal to a low impedance mic level balanced signal.
[email protected] (212) 629-9430[email protected] (404) 855-2255