Beta 27 Side Address Supercardioid Microphone

<Type>Condenser (externally biased)</Type> <Frequency Response>20 to 20,000 Hz</Frequency Response> <Polar Pattern>Supercardioid</Polar Pattern> <Impedance>160 Ohm</Impedance> <Sensitivity at 1 kHz, open circuit voltage>-37 dBV/Pa, 1 Pascal=94 dB SPL</Sensitivity at 1 kHz, open circuit voltage> <></> <Maximum SPL, 1 kHz at 1% THD>1000 O load: 134 dB (148 dB, Pad on)</Maximum SPL, 1 kHz at 1% THD> <>2500 O load: 140 dB (154 dB, Pad on)</> <></> <Signal-to-Noise Ratio, referenced at 94 dB SPL at 1 kHz>85.5 dB; S/N ratio is difference between 94 dB SPL and equivalent SPL of self noise, A-weighted</Signal-to-Noise Ratio> <></> <Dynamic Range, at 1 kHz>1000 O load: 125.5 dB</Dynamic Range, at 1 kHz> <>2500 O load: 131.5 dB</> <></> <Common Mode Rejection, 20 Hz to 20 kHz>Greater than 50 dB</Common Mode Rejection. 20 Hz to 20 kHz> <></> <Clipping Level, 20Hz-20 kHz at 1% THD>1000 O load: 2.0 dBV</Clipping Level, 20Hz-20 kHz at 1% THD> <THD of microphone preamplifier when applied input signal is equivalent to cartridge output at specified SPL>2500 O load: 8.5 dBV</THD of microphone preamplifier when applied input signal is equivalent to cartridge output at specified SPL> <></> <Self Noise, typical, equivalent SPL, A-weighted>8.5 dB </Self Noise, typical, equivalent SPL, A-weighted> <Polarity>Positive pressure on diaphragm produces positive voltage on pin 2 with respect to pin 3</Polarity> <Switch Attenuator>-15 dB</Switch Attenuator> <Low Frequency Response>Flat; -6 dB/octave below 115 Hz; -18 dB/octave below 80 Hz</Low Frequency Response> <Connector>Three-pin professional audio (XLR), male</Connector> <Power Requirements>48 Vdc phantom, 5.6 mA</Power Requirements> <L x H x W>6.15in x 2.2in x 2.2in (156.2mm x 55.88mm x 55.88 mm)</L x H x W> <Weight>15.1 oz (428 g)</Weight>