Please check the item status before ordering or contact us if you need something urgently.
Close Announcement
Empty
18" long 1/8" (3.5mm) TRS male to 1/8" (3.5mm) TRS male and 1/8" (3.5mm) TRS female line level y-cable for monitoring and recording from a single output jack.
Single channel inline XLR3 preamp for dynamic and ribbon microphones.
Removes ground loop hum, mode noise & differentially induced hum in one device.
One foot cable for recording from an XLR mic on a mobile device. 3.5mm monitoring tap included
No connectors. Requires soldering.
Can be set to 15, 20, or 25 dB. Passes phantom power
Used to connect balanced and unbalanced devices having different signal levels or impedances.
Helps to eliminate electrical and mechanical noise in an audio system such as 60Hz electrical hum from AC power lines, low-frequency rumble caused by wind noise or air conditioning system, and stage/floor noise transmitted to a microphone through the microphone stand
Converts balanced line level signals to microphone level (50dB attenuation)
Reverses the phase (polarity) of a balanced audio signal. In line switch permits selection of normal or reversed polarity for comparison purposes.
RF filter, XLR in/out. Passes phantom power
700 Hz microphone-level signal
Allows any XLR microphone to connect directly to a computer via USB.
35" binder to USB cable for connecting the SX-LC8+ Linear Fader to Sound Devices 833, 888, and Scorpio recorders.
4.7" BNC to SMA 50 ohm cable for connecting an antenna to the SL-2.
Designed for the A20-Mini.
Four-pin Hirose connector (HR10-7P-4P).
6" Hirose 4-pin to 4-pin XLRM.
Set of two 22.7" right-angle MCX to right-angle SMA 50 ohms cable to connect antennas or RF distro systems to the SL-2.
USB-C to 2x USB-A Y-cable for powering the MixPre-3 or MixPre-6 recorder from a computer.
Balanced TA3 outputs to balanced XLR inputs for use with Sound Devices 633, 664, and 688 production mixers. Package of two.
Balanced XLR outputs to balanced TA3 inputs for use with Sound Devices 633, 664, and 688 production mixers. Package of two.
For 552, 664, MixPre, MixPre-D, or MP-2 tape output to 442/302 mix in.
For jamming time code to equipment with XLR connectors.
Set of two 24" TA5F to dual three-pin XLRF audio cables.
Hirose HR10-7P-4P compatible connector.
For use with Zaxcom Nomad, Maxx, RX-12, Sound Devices 5, 6, and7 series, 302, MixPre (v2), 442, Lectrosonics Octopack, Quadpack, and more.