Maxx Fully Loaded Mixer/Recorder/Wireless Transmitter

Block 20


  • Four full size XLR analog mic/line level inputs with 48 V Phantom power that incorporate the Zaxcom Nomad’s microphone preamps with NeverClip™
  • Two-channel output bus over two sets of output connectors (XLR and TA5) that can be individually configured as line, mic and consumer output levels.
  • Two-channel balanced monitor return and mono & tape outputs
  • All broadcast sample rates up to 192 KHz AES input allows mix eight inputs onto the stereo output buss
  • Maximum dynamic range at both mic and line level output and headphone out
  • Record four pre-fader ISO tracks along with the two-channel mix to SD card (with adapter) and Compact Flash
  • Digital wireless transmitter signal carries two channels of audio and SMTPE*
  • Input effects – 2-channel notch filter / softknee compressor / delay / high-pass filter
  • Full timecode reader / generator
  • Visual time code slate
  • AES Input – 4-channels of audio on 2 x AES inputs with sample rate conversion
  • Transmitter  - 2-channel audio transmitter* with time code,  broadcasts to any Zaxcom ENG receiver
  • 6-Channel Recording - Records 4 ISO inputs, pre or post-fader + 2-channel stereo bus
  • *Please note, timecode reception requires a QRX100 w/QIFB as the receiver

Consumer Alert

Some versions of this wireless microphone device may operate in portions of the 617-652 MHz or 663-698 MHz frequencies. Beginning in 2017, these frequencies are being transitioned by the Federal Communications Commission (FCC) to the 600 MHz service to meet increasing demand for wireless broadband services. Users of this device must cease operating on these frequencies no later than July 13, 2020. In addition, users of this device may be required to cease operations earlier than that date if their operations could cause harmful interference to a 600 MHz service licensee’s wireless operations on these frequencies. For more information, visit the FCC’s wireless microphone website at or call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC).

Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device.