Available with three styles of battery door for bag, plug-on transmitter, or bodypack use.
Battery eliminator replaces the batteries and door on the LR receiver to allow for DC power.
Battery eliminator replaces the batteries and door on the LT transmitter, allowing for DC power.
Battery eliminator for all SM series transmitters. Will work with single or dual battery SM units.
Two-piece protective cover for SSM transmitters which allows basic operation.
etherCON RJ45 feedthrough coupler for Cat5 cable extension.
Hypoallergenic waterproof tape. Ideal for securing lavaliers to skin. 5 yards.
Built to mount a microphone in a cup holder.
Set of two bungee cables and carabiners that clip to the Orca bag or product loops and hold headphones and cables.
8400mAh portable power bank with dual USB output for charging digital devices.
Moisture eliminator for use in cases where moisture control is an absolute necessity.
Set of ten wraps to ensure a comfortable, secure fit for earpieces.
Expands the range of the Roger earpiece approximately 50m per repeater.
Automatically reprograms Roger Earpieces within 2m to its frequency.
Allows 12T microphones to operate with 48V phantom power.
Provides transformer isolation between equipment.
10 sheets, totalling 240 pieces.
Precut and drilled lavalier mic quieting sleeves. 15 pieces.
Attenuates line level signals by 50dB to provide mic level output.
Flexible wire tool for quickly threading lav cables through clothing.
RF Protection for the RF Explorer WSUB1G, ISM Combo, 2.4G, and 433M-915M. Not required for WSUB3G 3G Combo, which has a built-in power limiter.
Allows attachment of a 3/8" thread accessory to a shoe mount.
Rain protection for Rycote Modular Windshield Kits, Super-Shield Medium and Small, and other windshields no longer than 43cm. Not meant for use during recording.
Power adapter for external powering Sennheiser G3 or G4 receivers. Available wired for BDS, 4-pin Hirose, or unterminated.
Removes ground loop hum, mode noise & differentially induced hum in one device.
One foot cable for recording from an XLR mic on a mobile device. 3.5mm monitoring tap included
No connectors. Requires soldering.
Can be set to 15, 20, or 25 dB. Passes phantom power
Used to connect balanced and unbalanced devices having different signal levels or impedances.
[email protected] (212) 629-9430[email protected] (404) 855-2255